|
|
|
|
Toyota Surf 2.4 Bioplantrix installation.We are getting TRULY ASTOUNDING results using this heater, take a look at the following graphs which were produced during testing the system on our Toyota Surf, we fitted temperature probes and recorded the data, once with the Bioplantrix unit switched on then the following day we did the same journey with the unit switched off. See Graph with unit switched on. Then compare this with Graph with unit switched off. Print these two documents out then you will be able to see them side by side TOTALLY AMAZING we are sure you will agree? Click here for graph showing effectiveness of induction heating using our four probe temperature data-logger. Now on sale buy it here.
Induction coils wrapped around injection pipes
temperature sensor (blue) inserted in last few turns
Induction unit installed on bracket and connected
coils and unit
3 position switch. Up position - auto - green lamp (switches unit on when engine started) .Mid position - off - no lamp. Down position - manual - red lamp (switch on for pre-heat with ignition on, not to be left on for extended periods without engine running)
finished install
|
Dieselveg
Copyright © Dieselveg Ltd. Not to be reproduced in whole or part without prior written consent. If you do wish to use any part of this website's content, email copyright@dieselveg.com with your request details. This is a guard against inappropriate use of our hard earned material and to ensure good quality contents in third party publications. |
