Fuel preliminary heating for installation into the inlet of fuel filters
having either 14mm x 1.5 or 16mm x 1.5 threads to 8mm, 10mm, or 13mm ID fuel
lines.
ATG Diesel-Therm 12V - filter version No. DH12 Thread M14x1.5 or
thread M16x1.5 for preliminary heating of Diesel or bio fuels (RME, bio
Diesel, vegetable oil) and avoids waxing or clogged fuel filters.
The
following components are included: electrical instantaneous water heater
(approx 200 W, length approx 6 cm), thermostat (temperature control), rotary
switch with control light, (indicates when heater is on), relay, wiring loom
with protective sleeving and relay base, fuse carrier with 16A fuse,
accessories bag including lugs and clips etc, detailed fitting instructions,
general operating permit.
The filter version is screwed in at the filter
inlet in place of the existing hollow screw (banjo) (spanner size 19mm for
M14x1.5 22mm for M16x1.5).
The filter version is used more often in trucks
and tractors or with older vehicles. Alternatively the Diesel-Therm can be
inserted just before fuel pumps, valves, etc.
We reserve the right to make
price and design changes and correct any mistakes.
